Lightweight 75mm whoop using the Walksnail 1S VTX and nano camera compatible with the FatShark Dominator HD / Walksnail Avatar goggles.
Specifications
- Brand Name: Happymodel
- Model: Moblite7 Walksnail
- Frame wheelbase: 75mm
- Weight: 33.5 gram without battery
- Size: 98mm*98mm*48mm
- Receiver option: SPI ELRS 2.4GHz
- Compatible with 1S Lipo battery or Lihv battery
- Battery Plug: GNB27 with apadter for PH2.0
FC Specifications
- SPI ELRS version Firmware target: CrazybeeF4SX1280
- MCU:STM32F411CEU6 (100MHz, 512K FLASH)
- Sensor: ICM20689 or ICM42688P or BMI270(SPI connection)
- Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)
- Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
- Built-in Betaflight OSD(SPI Control)
- Built-in SPI ExpressLRS receiver
- Built-in 5V 1A BEC
- Built-in voltage detection
ESC Specifications
- MCU upgraded to EFM8BB21
- Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)
- Currents: 5A continuous peak 6A (5 seconds)
- Support BLHeliSuite programmable
- Factory firmware: O_H_5_REV16_8.HEX
- Default protocol: DSHOT150/DSHOT300/DSHOT600
ELRS Specifications
- Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
- RF Frequency: 2.4GHz
- Telemetry output Power: <12dBm
- Receiver protocol: SPI ExpressLRS
- Could bind with ELRS V2.0 firmware TX module
Motor Specifications
- Model: RS1002 20000KV
- Configu-ration:9N12P
- Stator Diameter:10mm
- Stator Length:2mm
- Shaft Diameter:Φ1.5mm
- Motor Dimension(Dia.*Len):Φ13.5mm*12.5mm
- Weight(g):2.5g
- No.of Cells(Lipo):1S only
Prop Specifications
Camera Specifications
- Model: Avatar nano
- lmage Sensor: 1/2.7”Inch
- Resolution: 1080P/6Ofps,720P/120fps,72OP/6Ofps
- Ratio: 16/9 4/3
- Lens: 2.1mm
- FOV 170°
- Aperture: F2.0
- Shutter: Rolling shutter
- Min.Illumination: 0.001Lux
- Weight: 3.5g
- Dimensions: 14*14*17mm
- Coaxial Cable: 45mm
VTX Specifications
- Model: Avatar mini 1s VTX V2.0
- Communication Frequency: 5.725-5.850 GHz
- Transmitter Power(EIRP): FCC:<25.5dBm; CE:<14dBm; SRRC: <20dBm;MIC:<25dBm
- l/o Interface: JST1.O*6(Power in)JST1.O*4(USB)
- Mounting Holes: 25.5*25.5 mm
- Dimensions: 30*30*6.5 mm
- Storage: 8G
- Recording: 1080p/720p
- Weight: 6.8 g
- Operating Temperature: -20-40℃
- Channels: 8
- Wide Power lnput: 3.1V-5V
- Supported FC System: Betaflight
- OSD: Canvas mode
- Bitrate: 25mbps / 50mbps
- Latency: Average delay 22ms
- Antenna connector: IPEX
Package
- 1 x Happymodel Moblite7 Walksnail 1S 75mm Brushless HD FPV Whoop Drone -ELRS
- 1 x Moblite7 Spare Canopy
- 1 x Gemfan 1635-3 bi-blades propeller(4cw+4ccw)
- 1 x Propeller disassemble tool
- 1 x Screwdriver
- 1 x GNB27 to PH2.0 convertor wire